**IMPORTANT**

Due to planned industrial action, Royal Mail will not provide a collection service on Friday 29th September and Saturday 1st October. Orders below £35 may be affected. We will resume Royal Mail shipping regularly from Monday onwards.

Make Along with Naomi Craft Buddy: How to make an Envelope Box

Posted by Gaurav Wadhwani on

What you will need:

 Craft Buddy Forever Flowers Floral Cascade or Tangled Love Envelope box die set

Craft Buddy Tartan Check stencil

Craft Buddy stamping card x2 sheets

300gsm card of your choice x3 sheets

Craft Buddy Premium Quality glue

Ink pads of your choice (I used oxide inks in Saltwater Taft, Twisted Citron and Squeezed Lemonade)

Craft Buddy finger daubers

Bone folder

A4 die cutting machine 

Magnetic shim

 

Step 1

Decide which Envelope Die Set to use, either will work for this project

Step 2

You will need all of the dies in the set except the patterned panels. 

Step 3

Place the two sections of the back panel onto the magnetic shim and cut from 300gsm card. 

Step 4

Next select the two die sections that make up the front panel and cut one. 

Step 5

Cut two side panels.

Step 6

These pieces will make the envelope box. 

Step 7

Next use the outside cutting edges to cut out panels for your box from stamping card. 

 

Step 8

Using the inks and stencil. Apply ink to each panel piece. 

 

Step 9

Now the panels are ready to be glued onto the base pieces. 

 

Step 10

Score each base piece along the score lines before constructing. 

 

Step 11

Glue the two side panels to the front section of the box. 

Step 12

 Line up the back panel and glue this in place too.

 

Step 13

Fold over whilst still flat and glue final glue flap in place. Then glue the base of the box in place. 

 

TA-DAH!

 

 


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.